Shenzhen Bestgo Tech Co., Ltd.

Super-stable GSM Wireless Alarm System

Super-stable GSM Wireless Alarm System
Product Detailed

1.Simple control alarm system via SMS or Call
2.Metal remote control
3.Partial arm wireless alarm
4.3 wired+16 wireless zones

Products Name:

Smart GSM wireless alarm system

GSM 900/1800/1900 tri-bands wireless alarm system, can be used in most parts of the world
Full duplex communication with the host
Monitor the scene environment
Voice and SMS alert 
Arm or disarm by remote controller
Can make Home Arm and Out Arm mode(Partial Arm Function)
Call to set alarm ON, OFF, Monitor, Output, Intercom.
Send SMS to the alarm system to arm,disarm,Monitor,Output
5 group phone+room number
1 alarm monitor center phone number
2 phone to report arm and disarm status
Can program 7 groups of alarm messages
3 alarm zones for wired detector
16 alarm zones for wireless detector
System own 2 outputs for using with external circuit to control home appliance
Easily set ON or OFF for every wired or wireless alarm detector
SMS inform if AC power failure or recovery

Built-in Back-up battery in the wireless alarm system


Technical Parameter:
Operating Voltage: DC 12V
Static Current: ≤20mA
Alarm Current: ≤400mA
Wireless Receiving Frequency: 433MHz

Anti-interference: 1V/m frequency:20-1000 MHz
GSM frequency: 900/1800/1900MHZ
Outer Alarm siren volume: 110dB
Working condition: Temperature: -10º C-50º C
Humidity : ≤90%
Wired Zone : 3
Wireless Zone: 16.


Basic component of wireless alarm system:
- Control Panel 1 pc
- Wireless PIR detector 1 pc
- Wireless door(gap) sensor 1 pc
- Remote controller 2 pcs
- Antenna 1pc
- Mini wired siren 110dB/0.3m 1 pc
- Power adpater 1pc
- User manual 1pc

The Wireless Alarm System Terminals:GND; SIREN; RELAY1; RELAY2; SPEAKER(O3); O2; O1; I3; I2; I1
1.I1; I2; I3: These 3 ports for input, every port can be connected with ground or open to make alarm out.
2.O1; O2: These 2 ports for output, you can call in or send SMS to set it. If output of these ports goes high, the light of OUT 1 or OUT 2 will light on the panel. (NOTE: these ports must be connected with external circuit, un-professionals should use with caution !!!)
3.SPEAKER(O3): This port is for voice output, it can be connected to the speaker. The other port of the speaker is connected to ground. You can control it by call in or send the SMS to the alarm system. If this function avails, the light of OUT 3 will light on the panel.
4.RELAY1; RELAY2: These two ports will be closed for 3 minutes when alarm happens. You can use these two ports to start the power supply of the camera when alarm happens. This function can be disabled by set command: 16#1#. You can also make this relay close or open anytime by sending SMS or phone calls (94#1# or 94#0# ).
5.SIREN: This port outputs siren tone alarm, it is to be connected with the siren. The other port of siren to be connected to ground.
6.GND: power ground.

The packing of wireless alarm  system is neutral color box+plister

Optional Accessories of the Wireless Alarm System Kit,Siren,Metal Remote Control,Wireless Door Sensor,Wireless Panic Button,Wireless Smoke Alarm,Wireless PIR Detector,Wireless Outdoor Siren

Copyright Notice @ 2008-2013 B2BAGE Limited and/or its subsidiaries and licensors. All rights reserved.